Table of Contents
Advertisement
Inno Roll HP
Slave Mode -
This will let you set unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until "Slave Mode" is displayed,
press ENTER. Either "Slave 1" or "Slave 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, then press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to "Slave 2", the
fixtures will now have contrast movement to each other.
Split Color
- Split Color mode. With this mode active,
color output will be split and whole. This mode needs to be
activated for the split color to work in DMX Mode.
1. Press the MENU button until "Split Color" is displayed, press
ENTER.
2. Either "Yes" or "No" will now be displayed. Use the UP or
DOWN buttons to toggle between "Yes" and "No".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Dimmer Limit
- In this mode you can adjust the LED
output intensity. This adjustment is used to match up with
the output intensity of other LEDs. Over time LEDs will start
to fade, this mode will let you match the intensity of a faded
LED.
1. Press the MENU button until "Dimmer Limit" is displayed,
press ENTER.
2. A number between 50-100 will be displayed. Press the UP
or DOWN buttons to adjust the LED output intensity. 50 being
medium intensity, and 100 being full intensity.
3. When you have found your desired setting press ENTER to
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 10
System Menu
Inno Roll HP
confirm.
Sound Mode
active mode.
1. Press the MENU button until "Sound Mode" is displayed,
press ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
DMX State
mode, that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go
into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when
power is applied.
1. Press the MENU button until "DMX State" is displayed, press
ENTER.
2. Either "Master/Slave", "Blackout", or "Last State" will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal is lost or power is applied, the
- In this mode the unit will run in sound
- In this mode you can adjust the sound
- This mode can be used as a precaution
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 11
System Menu
Advertisement
Table of Contents
