Checking Transmission Fluid Level; Checking And Refueling - Kioti CK25 Manual

10-4 CK25/30
CHECKING TRANSMISSION FLUID
LEVEL
(1) Oil Filler Plug (2) Gauge
(A) Oil Level is Acceptable Within This Range.
1. Park the machine on a flat surface,
lower the implement and shut off
engine.
2. Check the fluid level on the fluid level
dipstick. If the level is too low, add
new oil to the prescribed level at the
oil inlet.
(See "LUBRICANTS" in Maintenance
Section)
IMPORTANT
If oil level is low, do not run engine.

CHECKING AND REFUELING

704OA05B
(1) Fuel Tank Cap
Fuel tank
capacity
CAUTION
To avoid personal injury:
Do not smoke while refueling.
Be sure to stop the engine before
refueling.
1. Turn the key switch to "ON", check the
amount of fuel by fuel gauge.
2. Fill fuel tank when fuel gauge shows
1/4 or less fuel in tank.
3. Use grade No.2-Diesel fuel at tempera-
tures above -10°C (14°F).
Do not permit dirt or trash to get into
the fuel system.
Be careful not to let the fuel tank
704OA06A become empty, otherwise air will
enter the fuel system, necessi-
tating bleeding before next en-
gine start.
Be careful not to spill during
30
refueling. If spills occur, wipe it
(7.9 U.S.gal.) off at once, as it may cause a fire.
To prevent condensation (water) ac-
cumulation in the fuel tank, fill the
tank before parking overnight.
No.2-D is a distillate fuel of lower vola-
tility for engines in industrial and heavy
mobile service. (SAE J313 JUN87)
Grade of Diesel Fuel Oil According to
ASTM D975
IMPORTANT
NOTE