3-Point Hitch; Make Preparations For Attaching Implement; Attaching And Detaching Implements; Selecting The Top Link Mounting Holes - Kioti CK25 Manual

6-4 CK25/30

3-POINT HITCH

MAKE PREPARATIONS FOR
ATTACHING IMPLEMENT
SELECTING THE TOP LINK MOUNTING
HOLES
Select the proper set of holes to give you
the proper lift of the implement you are
using. This requires some experiment-
ation to achieve proper lift. Remove the
clip pin, then the bolt, move to chosen
hole, replace pin and clip.
DRAWBAR
Remove the drawbar if close mounted
implement is being attached.
ATTACHING AND DETACHING
IMPLEMENTS
704O603A
(1) Crank Lifting Rod (Right)
(3) Lower Link
To avoid personal injury:
Be sure to stop the engine.
Do not stand between tractor and
implement unless parking brake is
applied.
Before attaching or detaching
implement, locate the tractor and
implement on a firm level surface.
Whenever an implement or other at-
tachment is connected to the tractor
3-point hitch, check full range of op-
eration for interference, binding or P.
T.O separation.
CRANK LIFTING ROD (RIGHT)
Crank Lift Rod - To adjust the horizon-
tal position of the implement turn the
handle on the right lift rod. Most imple-
ments are designed to operate level. Set
the position desired by placing the lock-
ing unit over the handle as illustrated.
TOP LINK
1. Adjust the angle of the implement to
2. The proper length of the top link varies
704O604A
(2) Handle
CAUTION
the desired position by shortening or
lengthening the top link.
according to the type of implement be-
ing used.