MIXED CONTROL(IF EQUIPPED)
(1) Ground Surface
(3) Soft Soil
(2) Implement Penetration Limit
In draft control, when draft decreases, the
implement automatically lowers to in-
crease draft. However, the implement
sometimes lowers too much. To limit the
degree, the implement can be lowered,
set the position control lever at the low-
est working depth desire for the
implement. Lower the draft control lever
to the point where the implement is at the
desired depth.
This stops the implement from going too
deep and causing loss of traction and
ground speed.
IMPLEMENT LOWERING LIMIT
704O703A
(1) Position Control Lever
(2) Lock Bolt
The lower limit can be adjusted by mov-
ing the position of the locker. Shifting the
locker backward raises the lower limit and
shifting the locker forward lowers the
lower limit.
3-POINT HITCH LOWERING SPEED
704O704B
(1) 3-Point Lowering Speed Knob
(A) FAST
(B) SLOW
CAUTION
To avoid personal injury:
Fast lowering speed may cause
damage or injury. Lowering speed of
implement should be adjusted to two
or more seconds.
The lowering speed of the 3-point hitch
can be controlled by adjusting the 3-point
lowering speed knob.
HYDRAULIC UNIT 7-3
704O705B
(C) LOCK