Jump Starting; Warm-Up And Transmission Oil In The Low Temperature Range - Kioti CK25 Manual

WARM-UP AND TRANSMISSION OIL IN
THE LOW TEMPERATURE RANGE
Hydraulic oil serves as transmission
fluid. In cold weather, the oil may be
cold with increased viscosity. This can
cause delayed oil circulation or abnor-
mally low hydraulic pressure for some
time after engine start-up. This in turn
can result in trouble in the hydraulic
system. To prevent the above, observe
the following instructions:
Warm up the engine at about 50 % of
rated rpm according to the table below:
Ambient Warm-up time
temperature requirement
Above 0 °C
At least 5 minutes
(32 °F)
0 ~ -10 °C
5 ~ 10 minutes
(32 ~ 14 °F)
-10 ~ -20 °C
10 ~ 20 minutes
(14 ~ -4 °F)
Below -20 °C
More than 20
(-4 °F)
minutes
IMPORTANT
Do not operate the tractor under full
load condition until it is sufficiently
warmed up.

JUMP STARTING

Connect cables in numerical order. Disconnect
in reverse order after use.
(1) Dead Battery
(2) Jumper Cables (3) Helper Battery
When jump starting the engine, follow the
instructions below to safely start the
engine.
1. Use a battery of the same voltage as
the disabled tractor to jump start the
tractor. Locate the good battery in a
safe place where the jumper cables will
reach.
2. Set the parking brake and turn the key
switch to OFF.
3. Put on safety goggles and rubber
gloves.
4. Attach the red clamp to the positive
terminal of the dead battery, and at-
tach the other end to the positive ter-
minal of the helper battery.
5. Clamp the black cable to the Engine
hooks, and attach the other end to the
negative cable of the helper battery.
6. If the helper battery is in another
vehicle, do not allow the tractor and the
other vehicle to touch. Start the
704O511A
vehicle's engine after connecting the
cables and let it run for a few moments.
Turn of f all accessories on both
vehicles. Then start the disabled
tractor.
7. Disconnect the battery cables in the
exact opposite order as they were
attached.
OPERATION 5-9