Table of Contents
Advertisement
6. Click the arrow buttons for Azimuth or Elevation to change the offset. The current
position is shown on the screen.
Enable line up mode is only used during troubleshooting.
4.1.6
Navigation
On this page you can enter a fixed position or a fixed base heading.
Do as follows:
1. Select SERVICE > Navigation from the left navigation pane.
2. Set the Position and Orientation:
Item
Position mode GPS - GNSS module is used for current position (default).
Compass mode Automatic - magnetic heading is used (default).
3. Click Apply to save the new settings.
98-143492-B
Figure 4-8: Web interface: SERVICE > Navigation
Manual - enter values from other position source. (Accuracy should
be better than 50 m.)
Manual - enter a value for the direction of the EXPLORER 5075GX as
an alternative to the magnetic heading (0 to 360 degrees, precision
±20°).
Table 4-4: Web interface: SERVICE > Navigation
Chapter 4: Setup and operation
Setup using the web interface
Description
4-11
Advertisement
Table of Contents
Need help?
Do you have a question about the EXPLORER 5075GX and is the answer not in the manual?