Region Entrance Detection - HIKVISION DS-9600NI-I8 Series User Manual

7. Set the arming schedule. Refer to Configure Arming Schedule .
8. Set linkage actions. Refer to Configure Linkage Actions .
9. Click Apply.

6.2.6 Region Entrance Detection

Region entrance detection detects objects that enter a predefined virtual region.
Steps
1. Go to System Management → Event Settings → Smart Event .
2. Click Region Entrance Detection.
3. Select a camera.
4. Check Enable Region Entrance Detection.
5. Optional: Check Save VCA Picture to save the captured pictures of region entrance detection
pictures.
6. Set detection rules and detection areas.
1) Select Arming Region. Up to 4 regions are selectable.
2) Set Sensitivity. The higher the value is, the easier the detection alarm will be triggered. Its
range is [0-100].
3) Click Draw Region, and draw a quadrilateral in the preview window.
7. Set the arming schedule. Refer to Configure Arming Schedule .
8. Set linkage actions. Refer to Configure Linkage Actions .
9. Click Apply.
Network Video Recorder User Manual
Figure 6-9 Region Entrance Detection
60