HIKVISION DS-9600NI-I8 Series User Manual page 28

Add PoE Camera
Steps
1. Go to Camera → Camera → PoE Settings .
2. Enable or disable long network cable mode by selecting Long Distance or Short Distance.
Long Distance
Long-distance (100 to 300 meters) network transmissions via PoE interface.
Short Distance
Short-distance (< 100 meters) network transmission via PoE interface.
Note
• The PoE ports are enabled with the short distance mode by default.
• The bandwidth of IP camera connected to the PoE via long network cable (100 to 300 meters)
cannot exceed 6 MP.
• The allowed max. long network cable may be less than 300 meters depending on different IP
camera models and cable materials.
• When the transmission distance reaches 100 to 250 meters, you must use the CAT5E or CAT6
network cable to connect with the PoE interface.
• When the transmission distance reaches 250 to 300 meters, you must use the CAT6 network
cable to connect with the PoE interface.
• Refer to the Appendix 20.3 List of IP Cameras Connected to PoE by Long Network Cable (100 -
300 m) for the list of IP cameras.
3. Click Apply.
4. Connect PoE cameras to device PoE ports with network cables.
5. Go to Camera → Camera → IP Camera to view camera image and information.
Network Video Recorder User Manual
Figure 1-12 Add PoE Camera
11