Advertisement
SERVICE MANUAL
Positioning
grooves every
10 mm
For each rear wheel plate (right and left), loosen the two bolts A and screw off the two bolts B.
If you need to lower the seat height, it is necessary to remove the mudguard before adjustment because the tyre will touch the mudguard.
If the side guards are straight, you may leave them where they are.
Slide the rear unit which is made of the two wheel plates and the axle (no need to remove the rear wheels) upward or downward to the
desired height.
Insert the two bolts B taking care they pass through with no effort, even by screwing them, along the grooves and until they screw into the
threaded hole of the rear part of the wheel plate.
If the bolts do not pass easily, not even when screwing them, until the hole rear part of the plate, DO NOT force them, DO NOT hit them
because you may damage the carbon fibre, but adjust the height of the plate until the position that allows the bolts to go through with no
effort.
Once you have inserted the two bolts B on both wheel plates, screw them without tightening them.
Now, both wheel plates are positioned at the same height (make sure), but with both bolts A and B loos-
ened.
The positioning of the wheel plate is quite precise, however, in order to let the bolts B pass through the
grooves, there is a minimum vertical play; it means that, at worst, once both wheel plates are fixed, there
may be a maximum difference of 0.5 mm between right and left side.
In order to avoid such difference, while you fix the plate, push it upward.
Now, fix the two bolts A and then the two bolts B.
Check/adjust the brakes.
Remember that the rear height adjustment can affect the seat inclination, thus, it is necessary to check
and adjust the fork angle, see adjustment sheet "fork angle".
Adapt the mudguard, see adjustment sheet "side guard".
It is advisable to spread a drop
of mild lock thread glue on the
on the bolts A and B.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
REAR HEIGHT
STANDARD REAR UNIT
B
C
Bolts C loosened
Bolts B removed
Push it up while tightening
the bolts A and B.
Service Manual DUKE 8
A
B
Advertisement
