Advertisement
SERVICE MANUAL
Angle adjustment
Raise the plate.
The arms A allow for raising the plate, but they are not involved in the angle adjustment.
The clamp B is the component that allows for angle adjustment.
Loosen the two grab screws D and the four bolts C.
With one hand, turn the clamp to the desired inclination.
Swing the plate down and let it rest on the clamp to check its inclination.
If you need more inclination, repeat the steps you made so far.
If you need less inclination, you can now simply push the plate down until the desired inclination.
Finally, raise the plate and tighten the bolts C first and then the grab screws D.
A
B
Regolazione in profondità
The plate is fixed to the rotation arms A with four bolts B.
The plate has six pre-drilled holes, whereas, the arms have five pre-drilled holes.
To change the position of the plate, remove the four bolts B.
Move the plate frontward or backward to the new position.
Insert and fix the four bolts B positioning them, as far from each other as possible.
1
2
3
4
The foremost position of the plate is given when you fix it through its holes 1 and 4 and those of the arm A 2 and 5.
DO NOT position the plate more forward than the provided foremost position: the plate will not lean over the clamp below.
The rearmost position of the plate, you have to fix the plate through its holes 4 and 6 and the arm's A 1 and 3.
DO NOT position the plate more backward than the provided foremost position: the points of the arms A will lean out of the plate.
Note: between the foremost and the rearmost positions, there are 6 cm.
Friction of flip-back movement
The arms A allow for raising the plate and you can adjust them in order to make the movement more
or less fluent.
You can adjust the movement by screwing (harder movement) or unscrewing (lighter movement) the
two bolts E.
If you tighten the two bolts hard, the plate will results nearly fixed.
At each adjustment, spread some mild
lock thread glue on the bolts B.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
ALUMINIUM FLIP-BACK FOOTPLATE
C D C
A
1
1
4
2
3
Foremost position
C D C
B
2
5
Rearmost position
B
4
6
A
A
Service Manual DUKE 23
1
3
Advertisement
