Advertisement
SERVICE MANUAL
B
A
Assemble the lock axle B with the corresponding nut. WARNING!
When you feel the nut starts to tighten, the torque is enough.
Assemble the side guard with the bolt A and the spacer E.
Let the bolt A through and insert two steel washers.
Position the white nylon washer on the plate and insert the plate. Then, put another white nylon washer, a steel washer and tighten
the nut while holding the bolt A. WARNING!
feel the nut starts to tighten, the torque is enough to make the side guard rigid.
Insert the ring D of the release string through the hole of the lock axle.
Once you have assembled both plates P, proceed with assembling the backrest.
Lean the backrest onto the seat.
Insert one bolt C plus washer through the upper slot of the plate and the spacer F and partly screw it into
the upper hole of the backrest tube G.
Carry out the same operation on the other side.
Turn the backrest until you can insert the second bolt C plus washer through the lower slot of the plate
and the spacer F and screw it into the lower hole of the backrest tube G.
Do not use the intermediate holes on the tube G.
Carry out the same operation on the other side.
Finally, adjust the backrest inclination – see adjustment sheet "backrest angle".
At each adjustment, spread some mild
lock thread glue on the bolts C.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
BACKREST POSITIONING
Seat depth / setting (point of balance)
E
A
DO NOT tighten the bolt/nut A too much; you may damage the carbon fibre tube. When you
A
X 2
A
DO NOT tighten the nut much; you may damage the carbon fibre tube.
F
C
D
G
C
Service Manual DUKE 30
G
NO
Advertisement
