Advertisement
SERVICE MANUAL
Setting (point of balance) change
You can change the setting only by replacing the rear wheel plate – see adjustment
sheet "setting".
There are three settings, each of which is determined by the length of the rear wheel
plate.
The interval from one setting to the next one is 15 mm.
Adapting the side guard.
Mark the point where you will have to drill a new hole on the rear side of side guard,
15 mm from the centre of the bolt V2, ahead (if more prudential) or behind (if more
active) according to the new setting.
Remove the bolt V2 and turn the side guard upward.
Drill a new 8 mm hole (possibly starting with a hole 3 mm wide, then 6 mm and finally
8 mm) on the side guard where you marked it.
Repeat the same operation for the other side guard.
Loosen the bolt V1 of both side guards.
Slide the side guard until aligning the new 8 mm hole to that on the frame from where
you earlier removed the bolt V2.
If sliding the side guard result difficult, loosen the bolt V1 a little more.
Insert the bolt V2, the different washers and tighten it with the nut. Same operation for
the other side guard.
Tighten the bolt V1 of both side guards.
Note: drilling the hole on the side guards results easier if you remove them.
To remove them, it is necessary to screw off the bolts V1, too.
To re-assemble them, proceed as mentioned above starting with the side guards
front fixed with the bolts V1 loosened.
It is not necessary to adjust the brakes.
Adjust the fork angle.
Notes: if you change the setting from active to prudential or vice-versa (30 mm) the
side guard may not be big enough. You may need to change it.
According to the adjustment, you may need to cut off a a little part of the rear side of
the side guard to prevent interference with the nut B.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
SIDE GUARD
15 15
V1
B
Follows next page
Service Manual DUKE 16
Advertisement
