Advertisement
FOOTPLATE DISTANCE
SERVICE MANUAL
Screw off the bolt A of both side of the frame.
Slide the tubes to the necessary height.
Make sure the height of the two sides is the same.
Insert the bolt A paying attention to fitting it with no effort into the
A
threaded hole B on the rear side of the support C.
A
The footplate tube's holes and the hole of the support B must be
aligned.
Finally, tighten the bolt A on both sides of the frame.
Do not force screwing the bolt, you may damage the thread of the
hole B. Should that occur, you can remedy by pass the threaded hole
with a M5 tap starting from the rear side of the support. If the thread is
too damaged to be repaired, you can pass the hole with a 5 mm drill
bit and fix the tube with a longer bolt, washer and nut.
You can not change the support C.
After adjustment, check that between the lower side of the footplate
and the ground there is at least 2 cm and that there is no interference
between footplate and casters.
C
(A)
C
C
B
FRONT
REAR
Service Manual DUKE 20
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
Advertisement
