Advertisement
BRAKE
SERVICE MANUAL
WHEN ADJUSTING THE BRAKES, THE TURES MUST BE INFLATED TO THE CORRECT PRESSURE (except solid tyre)
The position of the brake depends on the position of the rear wheel.
P
A
B
A
A
Loosen the headless bolt A located in the lower side of the support B.
Position the brake-knurled rod P at a distance D of a few millimetres and parallel to
the ground.
Temporarily tighten the headless bolt A and try the brake out to check if the adjust-
ment is good.
If necessary, repeat the same operation to reach the good adjustment.
A good adjustment has the brake not too hard to engage but braking, so you will
have to find the suitable compromise.
Once reached the correct position, tighten the headless bolt A.
Carry out the same operation on the other side.
The adjustment for the sport brake is the same except for the distance D, in fact,
the brake, in its resting position is far away from the tyre. Just make a few tries.
Service Manual DUKE 12
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
Advertisement
