3B. Static Address Installation - Avaya 4600 Series Installation Manual

IP Phone Installation Manual

3b. Static Address Installation

WARNING: Static addressing is only necessary when a DHCP server is unavailable. For ease of
maintenance and installation it is strongly recommended that a DHCP server is installed and that
static addressing avoided. Following a boot file upgrade static address information must be
reinstalled.
This process is not supported on 4601 and 5601 phones.
1. Follow the steps in 2. Phone Connection.
2. Start manual address programming by doing either of the following:
• When DHCP is shown on the phone press *.
• While the phone is on-hook and idle, press the following key sequence; Hold 2 3 3 7 #
(Hold A D D R #).
3. For details of entering data such as back spacing see Entering Data for Administrative Options.
4. The phone displays Phone=. This is the phone's IP address. Press # to accept the current value
or enter a value and then press #.
• If entering a new value, use the * key to enter a '.' character between digits. Use the < key
to backspace if necessary.
5. The phone displays CallSv=. This is the address of the Gatekeeper. Press # to accept the
current value or enter a value and then press #.
• If the IP Office is acting as the Gatekeeper, then this is the IP address of the IP Office
Control Unit (LAN1).
6. The phone displays CallSvPort=. This is the Gatekeeper transport layer port number, a value
between 0 and 65535. Press # to accept the current value or enter a value and then press #.
• For IP Office Gatekeeper operation, enter 1719 and then press #.
7. The phone displays Router=. This is the address of its default gateway. Press # to accept the
current value or enter a value and then press #.
• For IP Office operation, this is the IP address of the IP Office Control Unit.
8. The phone displays Mask=. This is its IP Mask (also called sub-net mask). Press # to accept the
current value or enter a value and then press #.
• This should match the IP mask set for the IP Office Control Unit.
9. The phone displays FileSv=. This is the address of the TFTP server. Press # to accept the
current value or enter a value and then press #.
• This should match the IP address of the PC running the Manager application.
10. The phone displays 802.1Q=auto. Press * twice to change the setting to 802.1Q=off, then press
# to accept this value.
11. The phone displays VLAN ID=0. Press # to accept this value.
12. The phone displays Save new values?. Press # to save the new values you have entered. New
values being saved is shown, the phone then resets.
13. Installation is now the same as from Step 3 of DHCP Address Installation, see 3a. DHCP
Address Installation.
Note: If a new boot program is downloaded from the TFTP server after you enter static addressing
information, you will need to reenter your static addressing information.
IP Phone Installation
IP Office 3.1 Issue 11c (14th September 2005)
Page 24