Feed Rotor Check - Horizon Fitness PF-P330 Manual

3: Adjusting and Checking Procedures
3-9

Feed Rotor Check

PF-P330 has the same feed rotor that is
installed on collating machine VAC-100.
Check
1 The cutouts on both edge of the
vacuum pipe face the bottom. (Fig.2)
The setting blocks (front and rear)
2
faces at same angle and level to each
other. (Fig.2)
3 The edge of the pipe positions 60 mm
(2.4") ahead from face of the setting
block. (At front and rear) (Fig.2)
The shrink amount of the wave washer
4
is 2 mm (0.08".) (Fig.3)
[Additional Information]
The stretching force of the washer removes
the gap in the thrust direction.
The torque on the setting block is
5
11kg/cm. (Fig.2)
The installed feed rotor rotates
6
smoothly.
Wave Washer
Feed Ring
WW-30
Vacuum Rotor
Thrust Ring
Setting Block
Grease 6 Can be turned
This parts (front
2
does not
smoothly by hand.
/rear) are at the
come out.
same angle.
N4
60 mm
3
(2.4")
SB4-20
Torque
5
11kg / cm
1
Cutout at the bottom
Fig.2 Feed Roller (front)
Profile
Holes at the
bottom
Vacuum Pipe
Fig.1 Feed Rotor Unit
Thrust Ring
4 Shrink
amount
Fig.3 Wave Washer
3-10
Vacuum Pipe
This pipe does not rotate.
Suctions air the holes
at the bottom.
Vacuum Rotor
This ring rotates and suctions
the sheet through the radial slits.
Wave Washer
WW-30
Setting Block
(rear)
= 2 mm
(0.08")