Calibrating The Home Position (Buckle Chute Stopper) - Horizon Fitness PF-P330 Manual

2: Service Mode
2-2

Calibrating the Home Position (Buckle Chute Stopper)

On the PF-P330, the home position of the
buckle chute stopper only should be
calibrated manually.
Fold one sheet and adjust the home posi-
tion depending on the shift of the folded
sheet.
Perform the single folding.
Measure the shift of the fold position.
(Fig.1)
Adjust the first buckle chute home posi-
tion sensor B01 by the half of the folding
shift. (Fig.2)
Perform the parallel folding.
Measure the shift of the fold position.
(Fig.1)
Adjust the second buckle chute home
position sensor B02 by the half of the
folding shift.
[Additional Information]
After the fold pattern and sheet size are
selected, the stopper lowers. When the home
position sensor detects the stopper, the
motor reverses and the stopper lifts.
The stopper moving amount is calculated
from the fold pattern and the sheet size.
Therefore, if the sensor position is shifted
upward, the stopper position is also shifted
upward by the same amount.
2
Service Mode
Delivered with this
face top.
Raise the B01
by the half of the
Single Fold
shift.
Delivered with this
face top.
Raise the B02
by the half of the
shift.
Parallel Fold
Fig.1 Adjusting Amount
The sensor position
is adjustable within
the range of this slot.
B01
Fig.2 The First Buckle Chute Home Position
Sensor B01
2-2 Adjusting the Home Position (Buckle Chute Stopper)
The Second
Stopper
B02
The Second
Buckle Chute
Buckle Chute
Home Position
Side
Sensor
5 3
4 2
Deflector
Fig.3 Folding Unit
The First
Stopper
B01
The First
Buckle Chute
Home Position
Sensor
1
2-3