Stopper (Roller Lever) Position Adjustment - Horizon Fitness PF-P330 Manual

3: Adjusting and Checking Procedures
3-7

Stopper (Roller Lever) Position Adjustment

The stopper of the roller lever prevents the
removable rollers (the second and fourth
rollers) from compressing the other rollers
(the first, third and fifth rollers) too much.
(Fig.1)
If the rollers are compressed each other for
a long time, the roller lever is raised gradu-
ally. To avoid that, limit the pressure of
compressing the rollers by the stopper
position.
When the stopper positions as shown in
the Fig.2-A, the second and fourth rollers
can not touch the first, third and fifth
rollers and can not fold a sheet.
When the stopper positions as shown in
the Fig.2-B, the second and fourth rollers
compress the first, third and fifth rollers
too much. If the rollers are left as such for
a long period, they may be deformed.
Install the second and fourth rollers.
Adjust the eccentric stopper angle.
- Set the stopper so that the hole for Allen wrench
positions at the delivery (exit) side.
Set the gap between the stopper and
the roller lever.
- Fix the stopper so that the gap is 0.05 -0.15 mm
(0.002" -0.005".)
- In case of 64 gsm sheet, insert one or two sheets in
between and fix the eccentric stopper.
Spring
5 3
4 2
Stopper
Roller Lever
Fig.1 Roller Unit
5 3
4 2
(When the eccentric stopper positions as Fig.2 -B,
the rollers compress too much and are deformed.)
Fig.3 Roller Compressing
Eccentric Max.
1
A
Fig.2 Eccentric Stopper Position
Eccentric Stopper
Hole for Wrench
0.05 0.15 mm
1
0.002" 0.005"
Fig.4 Correct Gap
3-8
Eccentric Min.
B
Roller Lever