Motor Does Not Drive - Horizon Fitness PF-P330 Manual

4: Mechanical Troubleshooting

4-10 Motor Does Not Drive

Drive motor M01 does not drive
X10 Q03 X12
2A
S00
X11
Capacitor
SSR
K02
1 2
1 1
2 2
Check the followings:
1. The circuit protector Q03 for M01 is not
actuated.
2. The fixing screws on timing pulley of the M01
are fully tightened.
3. The voltage on the SSR terminal Pin2 and
BL connector X11 is 115/230VAC.
4. Wiring and connection between S00 - M01
(shown above) is OK.
Table Up/Down motor M02 does not drive
X02
M02
Table Up/Down Motor
24VDC
Geared Motor
M01
[ Moving Up/Down the Feed Table]
Turn OFF the power switch. Keep pressing the [5]
button on the numeric key pad and turn ON the power
switch. The blower, valve, clutch and table Up/Down
motor repeat the cycle of feeding operation. (To stop,
turn OFF the power switch.)
If the M02 does not drive, or does not try to
drive, check the followings:
1. When the fixing screw on the joint is loosened
and unloaded, the M02 drives.
2. The connectors of X02 and CON8 on QPM192
are OK.
3. The voltage of the X02 at the QPM192 side is
24VDC.
4. The voltage between the Pin5 and 6 of the
CON8 on QPM192 is 24VDC.
4-10: Motor Does Not Drive
4
Mechanical Troubleshooting
Buckle Chute Motors M03/M04 do not drive
QPM-192
QPM-192
CON6
CON8
GRN
5
BLU
6
[Moving the buckle chute stopper singly]
Turn OFF the power switch. Keep pressing the [1]
button on the numeric key pad, turn ON the power
switch. The machine starts moving the buckle chute
stopper. (To stop, turn OFF the power switch.)
Check the followings:
1. During moving buckle chute stopper (de-
scribed above), 24VDC is measured on X08
and X09.
2. 24VDC is measured between the Pin1 and 2,
or Pin3 and 4 of CON6 on QPM192.
3. There is a continuity between the terminals of
the circuit protector when it is pushed in.
1
The First
Circuit
Buckle Chute
Protector
X08
1
Q01 M03
X07
2
1
1 1
2
2 2
The Second
3 3
3
Buckle Chute
4 4
4 Q02
X09
5
1
M04
2
4-11