Deflector Position Adjustment - Horizon Fitness PF-P330 Manual

3: Adjusting and Checking Procedures
3-4

Deflector Position Adjustment

The deflector decides if the sheet is deliv-
ered or folded again.
The upper or lower limit of the deflector is
defined by the 15 hole on the side plate.
(Fig.2)
Remove the second and fourth rollers.
Loosen the fixing screws on the deflec-
tor holder. (Fig.3)
Insert a 0.5 mm (0.02") thickness of the
sheet between the third roller and the
deflector. (Fig.3)
Lock the deflector holder.
- Hold up the deflector holder and tighten the fixing
screws.
- Remove the inserted sheet.
Adjust the solenoid position. (Fig.4)
- Position the solenoid so that when the plunger is
pushed in, the deflector touches the
hole. Tighten the fixing screws in that position.
Check
- Remove the fold roller drive belt. Keep pressing
plunger on the solenoid and turn the third roller
manually. Check that the roller turns silently (the
deflector does not touch the roller.)
3
Fig. 1 Deflector Drive Mechanism
0.5 mm (0.02") thickness of the sheet
5
4
15 side plate
- These screws set the position of the deflector.
- These screws can also adjust the tilt of the
deflector.
Fig. 3 Deflector Holder
3-4: Deflector Position Adjustment
Adjusting and Checking Procedures
Deflector
Fulcrum Shaft
Deflector
Deflector Holder
Deflector Lever (front)
Y02
Solenoid
Fig. 2 Solenoid ON/OFF and Deflector Position
3 1
2
Push In
Deflector Holder
Deflector
Side Plate
Deflector Holder
Deflector Lever
Solenoid ON:
15 Side Plate
Hole
Solenoid OFF:
5 3 1
4 2
Little gap
at this side
Fix the solenoid with this side
touches the side plate.
Solenoid Fixing Screws
Fig. 4 Solenoid Position Adjustment
3-5