Esc+Bl Upc-A Barcode (No Hri) - SATO WS4 Series Programming Reference Manual

Barcode
Available for
WS4 series

ESC+BL UPC-A Barcode (No HRI)

UPC-A Barcode
(No HRI)
ESC
Hex code
<1B>
16
Default setting None
When printer is powered off
Persistence of
Validity in a job
the command
Validity after a job
[Function]
Specifies UPC-A Barcode with start/end bar in the same length with guard bar.
[Format]
<BL>abbcccn~n
●Parameter
a Barcode type
b Narrow bar width
c Barcode height
n Print data
[Coding Example] Barcode type: UPC-A, Narrow bar width: 03, Barcode height: 120, Print data: 01234567890
<A>
<V>100<H>100<BL>H0312001234567890
<Q>2
<Z>
[Notes]
1. This command supports UPC-A. Selecting barcode type other than "H" will result in a command error.
2. Refer to the following settings.
Guard bar
Yes
3. If a parameter is specified out of the range, its behavior will not be supported.
4. When using command <D> to print UPC-A, the character bars will be all in the same length. The command <BL> will print the
start bar and end bar in the same length as that of guard bars
Guard bar
Print result of UPC-A by command <D>
BL Parameter
<42> <4C> abbcccn~n
16 16
Set parameter will not be retained
Becomes invalid after execution
Becomes invalid after the job
= H
= Valid range
= Valid range
= Data
Barcode setting
HRI
No
Guard bar
ESC+BL
: UPC-A("H"Fixed)
: 01 to 12 dots
: 001 to 999 dots
: 11 digits fixed
Ratio
Fixed
Guard bar
Print result of UPC-A by command <BL>
89
Guard bar