Esc+2D31 Qr Code (Model 1) - SATO WS4 Series Programming Reference Manual

2D Code
Available for
WS4 series

ESC+2D31 QR Code (Model 1)

QR Code (Model 1)
ESC
Hex code
<1B>
16
Default setting None
When printer is powered off
Persistence of
Validity in a job
the command
Validity after a job
[Function]
Specifies QR code (Model1)
[Format]
<2D31>,a,bb,c,d(,ee,ff,gg)
●Parameter
a Error correction level
b Size of one side of cell
c Data setting mode
Note that two different data setting modes above are available.
d Concatenation mode
In case concatenation mode is selected, the following settings are mandatory. If normal mode is selected, omit the settings below.
e Quantity of partitions by concatenation mode
(How many partitioned QR codes are concatenated.)
f Sequential number partitioned by concatenation
(Sequential numbering to each partitioned symbol)
g Concatenation parity data
(Parity data is a result of XOR calculation of entire data of QR Code expressed in Hexadecimal character.)
[Format] (Data portion)
<DS>k,n~n
<DN>mmmm,n~n
●Parameter
k Input character mode
This setting is only required when manual data setting is selected.
Use command <DN> for binary data input.
m Quantity of data
When auto data setting is selected, or binary data input is selected, Quantity of data shall be specified.
n Print data
2D31
<32> <44> <33> <31>
16 16 16 16
Set parameter will not be retained
Becomes invalid after execution
Becomes invalid after the job
= L
M
Q
H
= Valid range :
= 0
1
= 0
1
ESC+2D31
Parameter
,a,bb,c,d(,ee,ff,gg)
: 7％
: 15％
: 25％
: 30％
01 to 32 dots
: Manual
: Auto
: Normal mode
: Concatenation mode
= Valid range : 01 to 16
= Valid range : 01 to 16
= Valid range : 00 to FF
= 1 : Numeric mode
2 : Alphanumeric mode
3 : Kanji mode (ShiftJIS Kanji code)
= Valid range : 1 to 486
= Data
105