Network Hub Use With The Ncb-El Router; Ncb Router Tcp/Ip Configuration Using Ether/Plug - Johnson Controls Intelligent Fire Integrator ROUTMB Installation & Operation Manual

For johnson control echelon networks

Table of Contents

NCB-EL Routers

5.4 Network Hub use with the NCB-EL Router

A multi-port network hub (UL 864 Listed) that connects multiple devices to an Ethernet network

can be used with this router. In your routing make sure to do the following:

Step 1. Make sure all power is disconnected and verify the ground connection on the PNET-1 was

Step 2. Connect the router's 10BaseT connector to a PNET-1's IN (square end).

Step 3. Connect the PNET-1's OUT connector (round end) to one of the hub's PNET-1 OUT

NOTE: Power-limited and non-power-limited circuits must remain separated in the cabinet

power-limited wiring must remain at least 0.25 inches from any non-power-limited circuit wiring

all non-power-limited wiring along bottom of cabinet

wiring must enter and exit the cabinet through different knockouts and/or conduits.

Once the hardware is installed and all wiring connections made, this router must then be configured

for communication over the TCP/IP and Echelon networks. Refer to

Configuration" on page 53

made.

connector.

Figure 5.8 Network Hub Connection Diagram

for information.

IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09

Network Hub use with the NCB-EL Router

All power-limited and non-power-limited circuit

Section 7, "NCB-EL/FL

All

Run

Table of Contents