Table of Contents
Advertisement
NCB-EL Installation
NCB Series Router Disassembly/Assembly Procedure
If you find it necessary to disassemble and reassemble your NCB series router for any purpose use
this procedure as a guideline.
Step 1. Disconnect any power from the router.
Step 2. Disconnect any external network wiring and cables.
Step 3. Remove the phillips screws from both router plates.
Step 4. Remove the two hex nuts surrounding the ASYNC connector.
Step 5. Remove the two flat head screws inside the AUI connector.
Step 6. Grasp the plate with the AUI connector and gently pull to remove the router's
WARNING: NCB Router Disassembly
!
DO NOT grasp the NETWORK connector plate and pull to remove the router's boards/plates from the
router's cabinet. Doing so may damage the unit, causing the unit to malfunction when powered on
Doing so will void the unit's warranty.
Step 7. Perform your tasks related to you removing the router's internal parts (i.e. jumper
Step 8. Grasp the plate with the AUI connector and gently reinsert the router's boards/plates
WARNING: NCB Router Assembly
!
DO NOT grasp the NETWORK plate to insert the router's boards/parts into the router's cabinet
may damage the unit, causing the unit to malfunction when powered on
warranty
Step 9. Replace removed screws, hex nuts, and the back plate and screws.
IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09
boards/plates. Then place them on a ESD safe surface.
termination change, remove existing and attach new transceiver).
(NETWORK connector side first).
.
NCB-EL Routers
.
Doing so
.
Doing so will void the unit's
43
.
Advertisement
Table of Contents
