Table of Contents
Advertisement
4WRMB Repeaters
2.2.4 JNISCAB-1 Installation
This section details how to install the 4WRMB into the JNISCAB-1 enclosure. This enclosure is
provided with door and key lock.
Mounting the Enclosure to its Wall Position
Step 1. Use the provided key to unlock the enclosure cover.
Step 2. Remove the enclosure cover.
Step 3. Remove the mounting stud indicated in the figure below, if not removed the stud could
Step 4. Mount the enclosure to the wall. Refer to the enclosure mounting hole layout below.
This stud must
be removed
before installing
the board
16
possibly short the board.
0.25
0.50
0.50
12.0
Figure 2.3 JNISCAB-1 Mounting Hole Layout
IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09
4WRMB Installation
6.0
9.0
0.87
7.75
Advertisement
Table of Contents
