Table of Contents
Advertisement
NCB-EL Routers
5.3.6 Router Installation
Perform the installation and cable connections of the router using the following procedure as a
guideline.
Procedure
Step 1. Set all eight of the router's OPTION DIP switches to the UP position.
Step 2. Route your the Echelon network wires in conduit into the cabinet.
Step 3. Orient the router on the extended JNISCAB-5's top shelf.
Step 4. Connect the Ethernet cable from the router's 10Base-T Ethernet connector to the PNET-
Step 5. Connect your Local Area Network line to the PNET-1's OUT connector (round end).
Step 6. Connect your Echelon network wires to the router connector labeled NETWORK.
Step 7. Plug the router's transformer power supply into the router's DC power connector.
Step 8. Slide the router and shelf into the cabinet.
Step 9. Plug the router's power transformer into previously installed electrical outlet.
42
The router reads DIP switch settings at power-up or after you press the RESET button.
Figure 5.7 NCB Series Router Installation into the JNISCAB-5
1's IN connector (square end).
For information about using hubs with the PNET-1 refer to
NCB-EL Router" on page
IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09
44.
NCB-EL Installation
"Network Hub use with the
Advertisement
Table of Contents
