Ncb-Im Component Descriptions; Led Descriptions; Ncb-Im Installation; 1: Ncb-Im Requirements - Johnson Controls Intelligent Fire Integrator ROUTMB Installation & Operation Manual

For johnson control echelon networks
Table of Contents

Advertisement

NCB-IM Component Descriptions

4.3 NCB-IM Component Descriptions
Network LEDs
Hardware Reset
Pin for NCB Router

LED Descriptions

Each NCB-IM router has five LEDs that provide network and modem diagnostic information.
These LEDs function as follows:
ACT (yellow) Indicates a packet has been passed by the router.
ERR Red error color indicates one of three things:
• Always on: a diagnostic error has occurred.
• Slow flash or always on: insufficient configuration information is present.
• Quick flash: insufficient IP configuration information.
Power Green color indicates when power is present for the router.
• Flashes if DC input to module is below minimum required voltage.
• Flashes for two seconds if a Wink network message is sent to the network processor.

4.4 NCB-IM Installation

4.4.1 NCB-IM Requirements
To use a NCB-IM the following components are required:
"NCB-IM
Telephone wire media with RJ11 termination.
JNISCAB-5 enclosure (ordered separately).
HSP-121 Power Line Surge Suppressor (required and included with JNISCAB-5 order).
DITEK 2MLPL110B or EDCO PC2TEL line protectors (not included).

NCB-IM Components

These are the main components that are shipped with a NCB-EL order:
NCB-IM Network Combiner Module.
FTXC Echelon SMX network transceiver (installed).
NCB transformer power supply (+24 VDC 400mA, center POSITIVE, outer NEGATIVE).
4.4.2 Installation Overview
This is the recommended installation order for a NCB-IM:
"JNISCAB-5 Power Outlet and EDCO HSP-121B Installation" on page
"JNISCAB-5 Shelf Installation" on page
"Router Installation" on page
IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09
Echelon Network Connector
ERR
PWR
ACT
RESET
NCB NETWORK COMBINER
Transformer Power Connector
Figure 4.2 NCB Series Front Panel
Components".
31.
Optional Handset Connector
AUDIO CD OH
NETWORK
DC IN
CMD CSVC RSVC OPTION A
Service Pins
30.
NCB-IM Routers
Modem Line LEDs
Modem
LINE
Line RJ-11
Connector
ON 1
2
3
4
5
6
7
8
Configuration DIP Switches
28.
27

Advertisement

Table of Contents
loading

Table of Contents