Table of Contents
Advertisement
X Assembly
Overview
The system is assembled in the following procedure. To disassemble, please carry out the pro-
cedure in the reversed order.
1. Attach the front and rear panels to the system board.
2. Attach the top cover to the assembly.
3. Attach power board brackets and power board.
4. Attach the bottom cover.
The power board sits parallel to the system board, and may hinder the installation of particular
internal I/O interfaces. Please remove the power board first to access the internal I/O.
Bottom Cover
The internal I/O of the system is mainly accessed via the bottom side. The bottom metal cover
is secured onto the chassis with 14 F3*5 zinc-coated screws located at both sides and on the
bottom. Use a Phillips screwdriver to unscrew them.
Side
x14
User's Manual | VC230-AL
Bottom
Side
For particular models, there is a
memory heatsink attached to the
inside of the bottom cover. When
installing, orient the bottom cover
so that the heatsink sits right on top
of the memory.
Power Board
The power board is secured in the chassis via two brackets installed onto the front and the rear
panel. The mounting screw holes are as shown in the photo. Locate and align the mounting
holes, and screw the brackets to the chassis tight. Please make sure the brackets are oriented
correctly as illustrated. The two brackets shall perfectly mirror each other. The handles shall be
closer to the SO-DIMM socket on the mother board.
Mounting Screw Holes
x4
Chapter 2
HARDWARE INSTALLATION
e l
a n
t P
o n
F r
9
Advertisement
Table of Contents
