For Windows Xp - Klein 3900 Series Operation And Maintenance Manual

5-12
CHAPTER 5 Splashproof TPU
5.2.4
To configure the wireless network connection for Windows XP:
Refer to "Windows XP LAN Configuration Setup" on page C-15 and perform
1.
the first two steps to open the Network Connection dialog box. Then in Step 3,
right click Wireless Network Connection.
The Local Area Connection dialog box opens.
Continue with Step 4, and then in Step 5 change the IP address from
2.
192.168.0.82 to 192.168.0.83.
Click
3.
when removing the LAN connection.
Continue with Step 1 through Step 3 to begin setting up the FTP service. Then
4.
in Step 4, change the IP address from 192.168.0.82 to 192.168.0.83.
Click
5.
Refer to "TPU LAN Configuration Setup" on page C-23 and connect a
6.
Terminal PC running HyperTerminal to the DEBUG connector.
Verify that the VAC/12 VDC switch is in its center position which is off.
7.
Switch the RUN/STANDBY switch to RUN.
8.
Switch the VAC/12 VDC switch to VAC to apply AC power to the TPU and
9.
turn in on; switch to 12 VDC to apply DC power and turn it on. Refer to the
CAUTIONS on page 5-10.
When the TPU begins to boot up, press any key.
10.
Enter "c."
11.
Change the IP address from 192.168.0.82 to 192.168.0.83 for "host inet (h)."
12.
Turn the TPU off.
13.
Series 3900 Sonar System Operations and Maintenance Manual
Configuring the Wireless Network Connection

for Windows XP

.
OK
NOTE Once you have entered the IP address for the wireless network
connection, your computer will automatically select the local area network
(LAN) connection when connecting a LAN and the wireless connection
.
OK
NOTE It is normal for a spark to occur when connecting the DC power
cable to a battery, as the inverter is being powered up.
11214510, Rev. 02