Klein 3900 Series Operation And Maintenance Manual page 81

B-7
Startup Script
BLOVERRIDE {d = 0,1} (System 5000 only). Setting d = '1' limits the
number of beams to 4. Setting d = '0' uses 5 beams. Note: If Bathy is enabled,
number of beams is also limited to 4. Default is '0'.
DECIMATIONMODE (System 5900 only). This is a debug setting and
should not be used in normal operation. Current software ignores this
parameter.
TRANSMITMASK {d = 0 - 0xFFFF}. Sets the towfish transmit mask to 'd'.
Equivalent to the $XMd and $YMd commands.
MBSSXTRANSMITMASK {d = 0 - 0xFFFF} (System 5900 only). Sets the
towfish side scan transmit X mask to 'd'. Equivalent to the $XMd command.
MBSSYTRANSMITMASK {d = 0 - 0xFFFF} (System 5900 only). Sets the
towfish side scan transmit Y mask to 'd'. Equivalent to the $YMd command.
MBESXTRANSMITMASK {d = 0 - 0xFFFF} (System 7180/5900 only).
Sets the towfish echo sounder transmit X mask to 'd'. Equivalent to the $XMd
command.
MBSSYTRANSMITMASK {d = 0 - 0xFFFF} (System 7180/5900 only).
Sets the towfish echo sounder transmit Y mask to 'd'. Equivalent to the $YMd
command.
NAVECHO {d = 0,1}. For the System 3000, 5000, and 5900: Setting d = '1'
causes each GPS string that the TPU detects on COM1 to be output to the
debug COM2 port. Setting d = '0' turns off the debug navigation output.
Default is '0'.
For the System 7180/5900: Setting d = '1' causes any string from the SVP,
Transmissometer, Actuator, Depth Sensor, and GPS to be output to the debug
port. Setting d = '0' turns off the debug output. Default is '0'.
ENGINEVERSION {d = 0,1,2} (System 7XXX/5900 only). Sets the sample
rate depending on which 5900 engine is in the towfish. Set d = '0' for the 5900
Engine (sample rate of 22372.2 K samples/s). Set d = '1' for the 7200 Engine
(sample rate of 12500 Ksamples/s). Set d = '2' for the 7180/5900 Engine
(sample rate of 24000 Ksamples/s). Default is '0'
TOWFISHECHO {d = 0,1}. Setting d = '1' enables all commands sent to the
towfish to be echoed out the TPU debug port COM2. Setting d = '0' disables
the debug output. Default is '0'.
LBO {d = 0 - 7}). Sends the fish command $MZd.
SYS7KCONFIG1_32 {d = 0 - 0xFFFFFFF} (System 7XXX/5900 Only).
Sets the channel configuration mask for channels 1 thru 32 to 'd'. Each bit in
the mask enables a channel. For example 0x10000001 would enable channels 1
and 29 and disable all other channels.