Setting Up And Connecting The Splashproof Tpu - Klein 3900 Series Operation And Maintenance Manual

Power fuse.
transformer input and the input to the low voltage power supply. It is a 2-A,
5 x 20-mm slow-blow fuse rated for 250 volts (P/N 13000045).
Towfish fuse.
200 VDC power supply. It is a 6.3-A, 5 x 20-mm slow-blow fuse rated for
250 volts (P/N 13000163).
GPS fuse.
input to the 12 VDC power supply. It is a 1-A, 5 x 20-mm fast-acting fuse rated
for 250 volts (P/N 13000161).
Transformer.
the setting of the VOLTAGE SELECT switch. The transformer output voltage
is 200 VAC which is input to the 200 VDC power supply. (See CAUTIONS on
page 5-10 regarding the use of the VOLTAGE SELECT switch.)
Inverter.
switched to 12 VDC and a 12 VDC supply is connected to the 12 VDC
connector on the connector panel. The inverter output is 115 VAC which
provides the main AC input power for the TPU. When using +12 VDC to
power the TPU, the VOLTAGE SELECT switch must be switched to 115V.
Baffle fan.
VME fan.
Baffles.
allowing rain or spray inside the case.
Wireless router.
communications with the computer.
Antenna.
be left in the position shown in Figure 5-5 on page 5-4.
5.2

Setting up and Connecting the Splashproof TPU

Setting up and connecting the Splashproof TPU is described in APPENDIX C:
"General Setup and Configuration." In addition, power connections are required as
described below. Furthermore, if the optional wireless router is installed, and you
will be using this option, you do not require a Ethernet Hub and you must change
the IP address settings both in your computer and in the TPU.
Setting up and Connecting the Splashproof TPU
The power fuse is in series with the main AC power input, the
The towfish fuse is in series with the 200 VDC output of the
The GPS fuse is in series with the main AC power input and the
The transformer inputs either 115 or 230 VAC, depending on
The inverter inputs +12 VDC when the VAC/12 VDC switch is
The baffle fan provides cooling for the inside of the case.
The VME fan provides cooling for the VME chassis.
The baffles allow air to flow out of the case to cool the inside without
The wireless router is optional and is used for wireless
The antenna is attached to the optional wireless router and should
NOTE The optional wireless router is available for the Series 3000 System
only. It is not an available option for the Series 3900 system.
5-9