Table of Contents
Advertisement
2.
Press |INDEX| until the cursor in the top line starts flashing, then use the |Up|
and |Down| buttons to select the index number position.
3.
Press |COMMENT| again to go to the list of symbols in the lower section. The active
symbol then gets highlighted. Use the |Up| and |Down| buttons to select another
symbol if necessary.
4.
Press the |Shift/Enter| button to insert the selected symbol from the list into the
selected position on the top line. The comment can include up to 10 symbols total,
with 7 symbols for the comment text and 3 numbers for the comment number.
Press |CLEAR| to reset the index position to "000" when |INDEX| is selected or erase
5.
the whole note when |COMMENT| is selected.
6.
To erase a symbol in the note, place the cursor after that symbol, then select the left
arrow ( ) and execute the command by pressing the |Shift/Enter| button.
7.
To save the note for the next measurement and exit the NOTE mode, press the |F3|
(EXIT) button.
To save the current measurement results with the current note:
Press the |Shift/Enter|+|Up| button combination (Save). The Saved notification is then briefly
shown onscreen, and current measurement results with the current note are saved in the
device memory.
Once the note is saved with measurement results, it cannot be edited.
FX87 DWDM Tunable Laser Source User's Manual
Page 24 of 39
Advertisement
Table of Contents
