Note!
The module does not support AHCI mode and should be configured via
the BIOS Setup Utility. Refer to Section 4.2.8 for more information.
C. USB Module Installation
1.
Follow Steps 1 ~ 2 of Subsection A.
2.
Retrieve the USB connector from the module case and affix it in place using two
screws. Connect the USB cable to the mainboard and secure with a cable tie
(see Fig. 2.50).
3.
Replace the VESA mount plate (as shown in Fig. 2.51) and secure in place
using four screws. Then replace the rear cover to complete the installation.
PPC-3150/3170/3190 User Manual
Figure 2.50
40