Table of Contents
Advertisement
6.
Connect the red SATA cable and power cable to their respective connectors,
and bind them together using a cable tie (see Fig. 2.43).
7.
Remove the two screws (circled in red) in the VESA mount plate to detach the
metal bracket from the underside of the mount plate (see Fig. 2.44).
Replace the VESA mount plate (as shown in Fig. 2.45) and secure in place
using four screws. Finally, replace the rear cover.
Note!
Retain the two screws removed from VESA mount plate to enable future
installation of an mSATA module.
PPC-3150/3170/3190 User Manual
Figure 2.43
Figure 2.44
36
Advertisement
Table of Contents
