LAI Games VIRTUAL RABBIDS THE BIG RIDE Operator's Manual page 51

5. Let the headset hang again and enter 150cm in the field shown below. Ensure the units are
set to cm, not in. Select CALIBRATE FLOOR. When the calibration is complete, select NEXT.
6. The calibration is complete. Select DONE to finish the process. Wait a few seconds for the
Virtual Rabbids software to start up.
7. If you are now switching to the other PC to calibrate a second headset, power down the
cabinet and wait 60 seconds. When the cabinet is powered on again, immediately change
the HDMI switch to PC2, and then repeat the above procedure.
8. Once both headsets are calibrated, shut down the machine again and wait 60 seconds
before powering on. The HDMI switch will default back to PC1.
51