LAI Games VIRTUAL RABBIDS THE BIG RIDE Operator's Manual page 34

56. Remove the 4x M10 lock nuts from the tower cable access area
57. Push the motion base and push it towards the tower, aligning it with the tower studs
58. Insert the connectors and cables into the cable access hole
59. Secure using the same 4x M10 lock nuts that were removed previously
60. Open the lower front door on the tower
61. Plug in all connectors from the motion base to the connector panel inside the tower, and
close the door
62. Install the warning signs to the motion base platform using 2x M6 screws and washers.
Ensure Loctite 242 is applied to these screws.
63. Complete the above step on the opposite side
34