LAI Games VIRTUAL RABBIDS THE BIG RIDE Operator's Manual page 30

33. Align the player handle studs to the holes
34. Holding the handle in place, secure it using 3x M10 lock nuts
35. Install M10 grounding plate followed by 1x lock nut
36. Connect the grounding connector to the plate
37. Reinstall the emergency button panel using the same screws that were removed from it.
Ensure that Loctite 242 is used on the screws before reinstalling them.
38. Take the foot rest and slide it down into place on the motion base, aligning the mounting
holes as shown below
39. Secure it using 6x M6 screws and washers. Ensure Loctite 242 is applied to these screws.
40. Repeat the previous two steps on the opposite side
30