Table of Contents
Advertisement
A M P R E S E A R C H P O W E R S T E P
EXPLODED VIEW
• Motor
• Hex Head Bolt
CAUTION: HANDLE WITH CARE.
To ensure our customers receive all components with full integrity, we pack the motors separate from their linkage
assemblies. This requires that the installer position and fasten the motor before continuing with the install. Please
follow the instructions below and handle the assembly carefully.
CAUTION: Dropping the assembly or any excessive impact MAY cause damage to the motor.
Instructions:
1. Position the gear cover in place as shown if not already in place.
2. Seat motor into position on the three mounting bosses. This may require an adjustment of the gear by moving
the swing arms.
3. After seating into place, fasten the motor with the three motor mount screws with 4mm Hex Head. Tighten
screws to 36 in-lbs (4N-m). Do not over torque.
www.amp-research.com
2
B
A
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN
THIS DRAWING IS THE SOLE
PROPERTY OF <COMPANY NAME >.
ANY REPRODUCTION IN PART OR AS
NEXT ASSY
A WHOLE WITHOUT THE WRITTEN
PERMISSION OF <COMPANY NAME>
IS PROHIBITED.
2
– J e e p W r a n g l e r J L
T M
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH
BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
MATERIAL
FINISH
USED ON
DO NOT SCALE DRAWING
APPLICATION
2/11
1
NAME
DATE
DRAWN
CHECKED
ENG APPR.
MFG APPR.
Q.A.
COMMENTS:
SIZE
DWG. NO.
jeep jk PSXL die cast linkage assembly
A
SCALE:1:8
WEIGHT:
1
IM77132 rev 08.07.19
B
A
REV.
SHEET 1 OF 1
Advertisement
Table of Contents
