A M P R E S E A R C H P O W E R S T E P
Attach front support bracket (28) by inserting
carriage bolt (14) into rail and using supplied button
head bolt (10), washer (18) and captive washer nut
(17) to pinch weld. Torque bolts to 16ft-lbs.
3
Install provided spacer (19) and M6 bolt (11) into
upper mount as shown on both the drive and idler
linkages. Do not tighten.
5
Using a 13mm socket Torque linkage bolts 4x (15)
from step 3 to 16 ft-lbs. Next use a 10mm socket,
torque linkage spacer bolt 2x (11) from step 6 to 8
ft-lbs. Once linkages are tight cycle board to verify
steps deploy under own weight.
7
www.amp-research.com
11
19
15
– J e e p W r a n g l e r J L
T M
Mount front drive linkage onto driver side. Thread
supplied bolts (15) into front drive linkage. Repeat
step for Rear idler linkage. Do not tighten.
4
Slide mounting T-nut into position. Center board in
rail pocket. Tighten fasteners to 10 ft-lbs.
6
Attach motor to linkage. Using a 13mm wrench
Torque to 36 in-lbs.
8
7/11
Remove fuses from Power
Step Wire Harness.
IM77132 rev 08.07.19