Table of Contents
Advertisement
Locate the white connector panel against passenger side kick panel area. Locate three connectors as
shown below and connect powerstep trigger wires as indicated in the chart. Match pin locations called out in
previous step.
Note: Plug reassembly is critical. Lever Arm of plug must be rotated completely locked in
1
14
the open position to engage properly!
On driver side, run Wire Harness leg down and along underside of the vehicle floor and frame to front Drive Linkage.
Connect harness to motor and secure harness with tie wraps. Route remainder of wire harness towards rear linkage
assembly for LED lights. Repeat step on passenger side.
29
6
5 15
Affix LED light XD bracket on rail. Slide
bracket into desired position and tighten using
5/32" Allen key.
1 16
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P
Door Ajar Wire
Color/ Stripe Color
Driver Front
Pass. Front
Driver Rear
Pass. Rear
31
– J e e p W r a n g l e r J L
T M
Pin location on
Vehicle Wire
Door Trigger
Module
Violet
3
Violet/White
8
Violet/Grey
4
Violet/Yellow
9
Using supplied butt connectors, connect the lamp wires.
Red to Red, Black to Black. Once Crimped use heat gun
to shrink tube. Close and wrap conduit with electrical tape.
Secure all loose wires with cable ties. Pull lamp wires
upward to avoid any wire snagging.
17
10/11
Connector
color
White
Blue
White
Black
31
30
IM77132 rev 08.07.19
Advertisement
Table of Contents
