Table of Contents
Advertisement
Remove sill plate cover. Remove grommet under floor and route trigger wires and power wire thru grommet.
12
1
Mount door trigger module to wire harness in
kick panel area. Using a 10mm socket remove
ground lug and connect ground to body.
Using supplied butt connectors connect red
wire on harness to red wire (Pin1)on module.
Next connect Purple with black stripe wire on
harness to purple with black stripe from module
(pin 6). Lastly connect Purple from harness to
purple on module (Pin 7). See next step for
trigger wire assembly.
Positive Supply
Red
Ground
BLK
Driver Front Input
PRP
Driver Rear Input
GRY
Not Used
-
5 13
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P
1
6
PRP/BLK Driver Side Output
2
7
PRP
Passenger Side Output
3
8
WHT
Passenger Front Input
4
9
YEL
Passenger Rear Input
5
10
-
Not Used
– J e e p W r a n g l e r J L
T M
9/11
IM77132 rev 08.07.19
Advertisement
Table of Contents
