Table of Contents
Advertisement
VB3i MANUAL
Logging
The VBOX3i has three logging modes that are selected and configured via VBOX setup with the supplied VBOXTools
software.
Log continuously:
With 'log continuously' ticked the VBOX will log data, regardless of movement.
Log only when moving:
Without 'log continuously' ticked then the VBOX will only log data to the CF card when it detects speed >0.5Km/h.
Advanced:
The advanced logging option on the VBOX3i allows any of the logged data channels to be used to trigger the logging
on the VBOX.
This is selected and configured through VBOX setup of the supplied VBOXTools software.
This facility allows a threshold value to be set as either > or < so that the logging will start or stop when a data value is
exceeded or not.
Multiple data channels can be combined in a Boolean 'OR' manner to control the logging.
LED indicators
There are a series of LED indicators on the front panel of the VBOX3i, their functionality is as follows:
SATS:
Flashing red indicates no satellites in view
Flashing green sequence indicates the number of GPS satellites currently being tracked. Each flash indicates a
satellite with a short pause between each sequence.
Flashing orange sequence indicates the number of GLONASS Satellites currently being tracked. Each flash
indicates a satellite with a short pause between each sequence.
Sequence showing 1 Satellite
Sequence showing 4 Satellites
Delay
1
Sequence showing 0 Satellites
Delay (Approximately 1 second )
Page | 9
1
1
2
3
4
1
Delay
1
Delay (Approximately 1 second )
1
2
3
4
22 May 2014
Advertisement
Table of Contents
