Review The Network Deployment And Default Configuration - Cisco Firepower 2100 Series Getting Started Manual

ASA Deployment in Platform Mode
Pre-Configuration
Pre-Configuration
Pre-Configuration
ASA CLI
Firepower Chassis
Manager
Firepower Chassis
Manager
ASDM
Cisco Commerce
Workspace
Smart Software Manager
ASDM
ASDM
ASDM
Firepower Chassis
Manager
FXOS CLI

Review the Network Deployment and Default Configuration

The following figure shows the default network deployment for the Firepower 2100 using the default
configuration in ASA Platform mode.
Note If you cannot use the default IP address for ASDM access, you can set the IP address at the ASA CLI. See
(Optional) Change the IP Address, on page
Review the Network Deployment and Default Configuration, on page
Cable the Device, on page 76.
Power on the Device, on page
Enable Platform Mode, on page
(Optional) Log Into the Firepower Chassis Manager, on page
(Optional) Enable Additional Interfaces in the Firepower Chassis Manager, on page
Log Into ASDM, on page 83.
Configure Licensing, on page
Configure Licensing, on page
Configure Licensing, on page
Configure the ASA, on page
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
FXOS remote management; allow FXOS to initiate management connections from an ASA
interface.
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
access lists to allow your management addresses; enable SNMP (HTTPS and SSH are enabled
by default); .
(Optional) Change the FXOS Management IP Addresses or Gateway, on page
Review the Network Deployment and Default Configuration
77.
77.
83: Obtain feature licenses.
83: Generate a license token for the chassis.
83: Configure feature licenses.
88.
80.
Cisco Firepower 2100 Getting Started Guide
73.
80.
81.
90: Enable
90: Configure
93.
73