Cisco Firepower 2100 Series Getting Started Manual page 99

ASA Deployment in Platform Mode
Example:
firepower-2110 /system/services # delete ip-block 192.168.45.0 24 https
firepower-2110 /system/services* # delete ip-block 192.168.45.0 24 ssh
firepower-2110 /system/services* #
Step 6 (Optional) Reenable the IPv4 DHCP server.
scope system
scope services
enable dhcp-server start_ip_address end_ip_address
You can also enable and disable the DHCP server in the Firepower Chassis Manager at Platform Settings >
DHCP.
Example:
firepower-2110# scope system
firepower-2110 /system # scope services
firepower-2110 /system/services # enable dhcp-server 192.168.4.10 192.168.4.20
Step 7
Save the configuration.
commit-buffer
Example:
firepower-2110 /system/services* # commit-buffer
Step 8 Change the ASA address to be on the correct network. The default ASA Management 1/1 interface IP address
is 192.168.45.1.
a) From the console, connect to the ASA CLI and access global configuration mode.
connect asa
enable
configure terminal
Example:
firepower-2110# connect asa
Attaching to Diagnostic CLI ... Press 'Ctrl+a then d' to detach.
Type help or '?' for a list of available commands.
ciscoasa> enable
Password:
The enable password is not set. Please set it now.
Enter Password: ******
Repeat Password: ******
ciscoasa# configure terminal
ciscoasa(config)#
b) Change the Management 1/1 IP address.
interface management1/1
(Optional) Change the FXOS Management IP Addresses or Gateway
Cisco Firepower 2100 Getting Started Guide
97