Cisco Firepower 2100 Series Getting Started Manual page 76

Firepower 2100 Platform Mode Default Configuration
Figure 18: Firepower 2100 in Your Network
Firepower 2100 Platform Mode Default Configuration
You can set the Firepower 2100 to run in Platform mode; Appliance mode is the default.
Note For pre-9.13(1) versions, Platform mode was the default and only option. If you upgrade from Platform mode,
this mode is maintained.
ASA Configuration
The default factory configuration for the ASA on the Firepower 2100 configures the following:
• inside→outside traffic flow—Ethernet 1/1 (outside), Ethernet 1/2 (inside)
• outside IP address from DHCP, inside IP address—192.168.1.1
• DHCP server on inside interface
• Default route from outside DHCP
• management—Management 1/1 (management), IP address 192.168.45.1
• ASDM access—Management hosts allowed.
• NAT—Interface PAT for all traffic from inside to outside.
• FXOS management traffic initiation—The FXOS chassis can initiate management traffic on the ASA
Cisco Firepower 2100 Getting Started Guide
74
outside interface.
ASA Deployment in Platform Mode