Cisco Firepower 2100 Series Getting Started Manual page 39

Firepower Threat Defense Deployment with FMC
• Host—Enter the IP address of the FTD you want to add. You can leave this field blank if you specified
both the FMC IP address and a NAT ID in the FTD initial configuration.
• Display Name—Enter the name for the FTD as you want it to display in the FMC.
• Registration Key—Enter the same registration key that you specified in the FTD initial configuration.
• Domain—Assign the device to a leaf domain if you have a multidomain environment.
• Group—Assign it to a device group if you are using groups.
• Access Control Policy—Choose an initial policy. Unless you already have a customized policy you
know you need to use, choose Create new policy, and choose Block all traffic. You can change this
later to allow traffic; see
• Smart Licensing—Assign the Smart Licenses you need for the features you want to deploy: Malware
(if you intend to use AMP malware inspection), Threat (if you intend to use intrusion prevention), and
URL (if you intend to implement category-based URL filtering).
Register the Firepower Threat Defense with the Firepower Management Center
Allow Traffic from Inside to Outside, on page
Cisco Firepower 2100 Getting Started Guide
46.
37