Access The Asa And Fxos Cli - Cisco Firepower 2100 Series Getting Started Manual

ASA Deployment in Platform Mode
You can create multiple entries for each protocol type. Set the Port if you do not want to use the following
defaults:
Step 3
Allow FXOS to initiate management connections from an ASA interface.
a) Choose FXOS Traffic Initiation from the navigation pane.
b) Click Add, and enable the ASA interfaces where you need to send FXOS management traffic. By default,
the outside interface is enabled.
Step 4
Click Apply.
Step 5 Connect to the Firepower Chassis Manager (by default https://192.168.45.45, with the username: admin and
the password you set at initial login).
Step 6 Click the Platform Settings tab, and enable SSH, HTTPS, or SNMP.
SSH and HTTPS are enabled by default.
Step 7 Configure an Access List on the Platform Settings tab to allow your management addresses. SSH and HTTPS
only allow the Management 1/1 192.168.45.0 network by default. You need to allow any addresses that you
specified in the FXOS Remote Management configuration on the ASA.

Access the ASA and FXOS CLI

This section describes how to connect to the FXOS and ASA console and how to connect to FXOS using
SSH.
Connect to the Console Port to Access FXOS and ASA CLI
The Firepower 2100 console port connects you to the FXOS CLI. From the FXOS CLI, you can then connect
to the ASA console, and back again.
You can only have one console connection at a time. When you connect to the ASA console from the FXOS
console, this connection is a persistent console connection, not like a Telnet or SSH connection.
Procedure
Step 1 Connect your management computer to the console port. The Firepower 2100 ships with a DB-9 to RJ-45
serial cable, so you will need a third party serial-to-USB cable to make the connection. Be sure to install any
necessary USB serial drivers for your operating system. Use the following serial settings:
• 9600 baud
• 8 data bits
• No parity
• HTTPS default port—3443
• SNMP default port—3061
• SSH default port—3022
Access the ASA and FXOS CLI
Cisco Firepower 2100 Getting Started Guide
91