Cisco Firepower 2100 Series Getting Started Manual page 51

Firepower Threat Defense Deployment with FMC
Procedure
Step 1
To log into the CLI, connect your management computer to the console port. See the hardware guide for your
device for more information about the console cable. Use the following serial settings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
Attention
Step 2
At the prompt, log into the FXOS CLI.
Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 3
Access the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see the
Step 4 To exit the FTD CLI, enter the exit or logout command.
Example:
> exit
firepower#
Note
The CLI on the console port is FXOS.
Cisco Firepower Threat Defense Command
This returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?. For usage information, see the
Reference.
Cisco Firepower FXOS Command
Cisco Firepower 2100 Getting Started Guide
Access the FTD and FXOS CLI
Reference.
49