Cisco Firepower 2100 Series Getting Started Manual page 31

Firepower Threat Defense Deployment with FMC
Figure 12: Cabling a Separate Management Network
a) Cable the following to your management network:
b) Connect the management computer to the console port. You need to use the console port to access the
CLI for initial setup if you do not use SSH to the Management interface.
c) Connect the inside interface (for example, Ethernet 1/2) to your inside router.
d) Connect the outside interface (for example, Ethernet 1/1) to your outside router.
e) Connect other networks to the remaining interfaces.
Step 2 Cable for an edge deployment:
• Management 1/1 interface
• Firepower Management Center
• Management computer
Cisco Firepower 2100 Getting Started Guide
Cable the Device
29