Access The Ftd And Fxos Cli - Cisco Firepower 2100 Series Getting Started Manual

Access the FTD and FXOS CLI

Procedure
Step 1
Click Deploy in the upper right.
Step 2
Select the device in the Deploy Policies dialog box, then click Deploy.
Step 3 Ensure that the deployment succeeds. Click the icon to the right of the Deploy button in the menu bar to see
status for deployments.
Access the FTD and FXOS CLI
Use the command-line interface (CLI) to set up the system and do basic system troubleshooting. You cannot
configure policies through a CLI session. You can access the CLI by connecting to the console port.
You can also access the FXOS CLI from the FTD CLI for troubleshooting purposes.
Note You can alternatively SSH to the Management interface of the FTD device. You can later connect to the
address on a data interface if you open the interface for SSH connections. SSH access to data interfaces is
disabled by default. This procedure describes console port access.
Cisco Firepower 2100 Getting Started Guide
48
Firepower Threat Defense Deployment with FMC